Stocking item, 30 day return policy applies

1987-96 F150 3 inch front/4 inch rear Lowering kit by DJM with shocks

DJM Suspension
DJM:300034S
lbs
    Delivery time:Normally ships within 48 hours
Add to cart
  • Description
  • More

DJM Suspension

Ships by  Truck Freight
300034S | 1987-96 F150 3 inch front/4 inch rear Lowering kit by DJM with shocks, 2WD only. A 3/4 kit just for your F-150. A set of DJM’s famous Dream Beams in the front gives you a 3" drop by replacing your factory beams with the DreamBeams. A Hanger/Shackle kit in the rear brings it down 4" to give you a great muscular stance  
Manufactured by DJM Suspension | 300034S |  1987-96 F150 3 inch front/4 inch rear Lowering kit by DJM with shocks,  2WD only. A 3/4 kit just for your F-150. A set of DJM’s famous Dream Beams in the front gives you a 3" drop by replacing your factory beams with the DreamBeams. A Hanger/Shackle kit in the rear brings it down 4" to give you a great muscular stance, What are Dreambeams? Ford I-Beam trucks have a much different suspension than most other trucks. Spindles are non-existent for lowering, using lowered coil springs cause more alignment problems than you can solve. Then we built Dream Beams. Twin I-Beams In 1965 Ford introduced their “Twin I Beam” suspension, a simple, rugged suspension consisting of a pair of cast beams in the rough shape of an I. Looking like a steel I beam found in building construction, the factory beams are cast ductile iron and machined just like spindles. This makes them precise and repeatable, every beam machined exactly the same. A very important attribute when it comes to alignment. Alignment can be a sticky issue because there is very little if any adjustment available on I-beam suspensions (No upper control arm). This just means in order to align properly, beams must be accurate. Which brings us back to – What are Dream Beams? You have probably seen dropped I-beams made of three flat pieces of metal welded together in the shape of an I. Some are pretty accurate and then there are others. The problem with beams constructed this way is in the design itself. It requires welding three flat metal surfaces with long welds. This generates a lot of heat, which causes warping, otherwise known as “weld creep”. This would not be a problem if you had some control of the “creep”, but sadly it warps the steel a little different every time. This makes the beams manufactured this way a little different every time one is welded up. Big trouble for alignment. But why is this important? Because there is no way to adjust caster with beams. It is set by the construction of the beam, and if the beam is not consistent (because of weld creep) during construction you will likely have some alignment issues.  Product information updated on 2024-07-04. This product can ship by Truck Freight