2006 to 2008 Dodge Ram 1500 4WD Regular or Quad Cab Lowering Kit

2006 to 2008 Dodge Ram 1500 4WD Regular or Quad Cab Lowering Kit
BellTech
KitRam064wd
Add to cart
  • Description
  • More

Lowering Kit Builder Tool. The Easy Way to Build Your Lowering Kit

Our lowering selection tool for the 2006 to 2008 Dodge Ram 1500 4WD Regular or Quad Cab Lowering Kit. Each kit can be selected with or without either Belltech NitroDrop 2 shocks, or Belltech Street Performance shocks.

The 2006, 2007 and 2008 Dodge Ram 4WD is available for lowering using the following kits.

The Lowering Kit is available in the following configurations. Drop the front of this Ram by 2-inches with spindles and the rear 3-inches with leafs.

Lowering the rear by more than 2 inches requires shorter shocks.

Kit Notes:

  • The spindles fit but are not approved for the 4wd truck. Drive axle wear may occur.

2006 to 2008 Dodge Ram 1500 4WD Regular or Quad Cab Lowering Kit

In 2006 Dodge changed to a coil-over strut design on the 4wd trucks. Ground Force does make a complete lowering kit but it's really pricey for what you get. The McGaughys spindles do still bolt up but the same disclaimer is given as with the newer Rams (you can have drive axle issues from lowering it. Use at your own risk)

In the rear is a typical leaf setup but replacement hangers are not an option and the shackle only has room for a one inch drop. So that means the most common drop is with a flip kit but a lot of times it goes down too far. Your best choice is to go with a set of BellTech replacement leaf springs that will give you 3 inches of drop.