2006 to 2008 Dodge Ram 1500 2WD Regular or Quad Cab Lowering Kit By Belltech

2006-08 Ram 1500 2WD Quad Cab, 2007-08 Reg Cab Lowering Kit
BellTech
KitRam062wd
Add to cart
  • Description
  • More

Lowering Kit Builder Tool. The Easy Way to Build Your Lowering Kit

Our lowering selection tool for the 2006 to 2008 Dodge Ram 1500 2WD Regular or Quad Cab Lowering Kit. Each kit can be selected with or without either Belltech NitroDrop 2 shocks, or Belltech Street Performance shocks.

Drop the suspension on your 2006, 2007 or 2008 Dodge Ram.

The Lowering Kit is available in the following configurations;

For this make and model of Ram truck, the front can be dropped by 2 inches using coils and the rear by 3 inches with leafs.

Another option would be dropping the front 2 inches with coils and lowering the rear by 5 inches with a flip kit but this has a tendency to leave the rear of the truck slightly lower than the front.

Lowering the rear by more than 2 inches requires shorter shocks.

If you have a 2006 Regular Cab you need to specify that in the notes as the leaf springs included with this kit will not work on that truck

2006 to 2008 Dodge Ram 1500 2WD Regular or Quad Cab Lowering Kit

The front suspension on the 2WD Ram 1500's is a typical control arm, coil and spindle combo that you can lower by replacing any of the items. But, there are some notes. They made a control arm change in 2006 so DJM's listing only works up to 2005. The spindles didn't change unless your truck is an SRT, then they had Brembo brakes so the spindles don't work.

In the rear is a typical leaf setup but replacement hangers are not an option and the shackle only has room for a one inch drop. So that means the most common drop is with a flip kit but a lot of times it goes down too far. Your best choice is to go with a set of BellTech replacement leaf springs that will give you 3 inches of drop.