Special order parts are not returnable

63-87 Chevy 2 inch front Coil Springs

DJM Suspension
DJM:CS23532
Add to cart
  • Description
  • More

Delivery time on DJM special order parts is 4 to 10 weeks

Special order, allow 4 to 8 weeks delivery
63-87 Chevy 2 inch front Coil Springs
Product updated on 2021-01-08, DJM Suspension -  DJM:CS23532,  63-87 Chevy 2 inch front Coil Springs, Priced As Pair - Easy Install - Instructions - No, Coil springs and torsion bars are the easiest way to lower a truck. Let’s face it, you can for almost no money, either heat or cut coil springs. Torsion bars are even easier. Its so tempting, too many people have either turned back their torsion bars, or cut their springs and tried to live with it, only to finally say “I can’t take it anymore”. If you have ever ridden in a truck lowered this way you know what I am saying. Ladies must wear sports bra’s, no piping hot drive-thru coffee on this trip. Well enough of that, it is the cheapest and oddly enough, the absolute worst way to lower a truck. But why does cheap have to be so bad? Lets explore – when you heat a coil, at the very least the area you heat up loses its spring temper (the ability of the steel to rebound or remember to return to its original position after it has been compressed) or in other words it just sets there like a lump. If the rest of the spring is not damaged (a big if) the rate will still increase a great deal while the stress applied to the spring increases even more. The spring is severely over levered. If you cut your springs the same thing happens. This is of course dependent on how much you cut. It is possible to trim springs to balance or fine tune a ride height, but were talking about removing 1/4 coil or less, and is generally done by very experienced installers, and it’s not going to lower your truck very much.